Qregpd for panel data

[Nermine Medhioub]

hello everyone, I have a problem with the Qregpd command. When I run qregpd in Stata, I get different results (with different signs in the coefficients) even when I set a seed. I don't understand what this variability depends on. I feel like I might be manipulating the results because I tend to record the outputs only when I get the appropriate results and signs. What should I do to address this issue?

[Carlo Lazzaro]

Nermine:
I would start with following the FAQ and share what you typed and what Stata gave you back. Thanks.